#Load from dbschema file informix license#

To delete all license files, enter the wildcard character (*) for filename. Connection 2.1 only: license filename deletes the license file that is specified by license.You cannot enter the wildcard character (*) in directory. Connection 2.1 only: dir tftp directory deletes the TFTP directory specified by directory.You can use the wildcard character, *, for filename. directory/filename specifies the path and filename of the file(s) to delete.inactivelog specifies a log on the inactive side.activelog specifies a log on the active side.

#Load from dbschema file informix install#

Install directory/filename Ĭonnection 2.1 only: dir tftp directory Ĭonnection 2.1 only: license filename See Example A-2.Īctivelog directory/filename Where command represents the command name or the command and parameter. To query only command syntax, at the CLI prompt, enter Where command specifies the command name or the command and parameter. To get detailed help, at the CLI prompt, enter Short query help that includes only command syntax.Detailed help that includes a definition of the command and an example of its use.You can get two kinds of help on any command: If you reach a command, keep pressing Tab, and the current command line repeats this indicates that no additional expansion is available.An * identifies the commands that have subcommands. For example, if you enter set and press Tab, you see all the set subcommands.

#Load from dbschema file informix full#

Enter a full command name and press Tab to display all the commands or subcommands that are available.

For example, if you enter se and press Tab, set gets completed.

Enter the start of a command and press Tab to complete the command.

The following section contains basic tips for using the command line interface.

Where adminname specifies the Administrator ID and hostname specifies the hostname that was defined during installation.įor example, ssh From a direct connection, you receive this prompt automatically: From a remote system, use SSH to connect securely to the Cisco IPT Platform.Step 1 Do one of the following actions depending on your method of access: Perform the following steps to start a CLI session: You will need this information to log in to the Cisco IPT Platform. Use this method if a problem exists with the IP address.Įnsure you have the following information that gets defined during installation:

#Load from dbschema file informix serial#

You can access the Cisco Unified Communications Operating System CLI directly by using the monitor and keyboard that you used during installation or by using a terminal server that is connected to the serial port.From a web client workstation, such as the workstation that you use for Cisco Unified Communications Operating System Administration, you can use SSH to connect securely to the Cisco Unified Communications Operating System.You can access the Cisco Unified Communications Operating System CLI remotely or locally: This appendix describes the CLI commands that are available on the Cisco Unified Communications Operating System server. Utils network connectivity (Connection 2.1 Only) Utils disaster_recovery show_registration Utils disaster_recovery show_backupfiles tape Utils disaster_recovery show_backupfiles network Utils dbreplication setrepltimeout (Connection 2.1 Only) Utils dbreplication dropadmindb (Connection 2.1 Only) Utils dbreplication clusterreset (Connection 2.1 Only) Utils create report (Connection 2.1 Only) Show tech system (Connection 2.0 Version) Show tech system (Connection 2.1 Version) Show tech runtime (Connection 2.0 Version) Show tech runtime (Connection 2.1 Version) Show tech network (Connection 2.0 Version) Show tech network (Connection 2.1 Version) Set network restore (Connection 2.1 Only) File fragmentation sdi (Connection 2.1 Only)įile fragmentation sdl (Connection 2.1 Only)